![]() If anyone can make sense of the above nonsense, and knows the answer, please let me know. i mean my tubes couldn't all have shorts in them. Is it possible you may do more tube testing in the future over what you do now. Except, that when I test the tubes, the light goes on at the numbers the chart says they should go on at, but then doesn't go off after. This is only a primer on the topic and not an all encompassing manual. Slide them one at a time, leaving each switch in the "P" position until they are all in the "P" position, then bring them back. ![]() Slide each switch up and down one at a time, which has got to be wrong, because then you would never have more than one switch in the "P" position, which is how it seems like you are supposed to tell when there is a short.Ģ. However, unless the tube chart indicates otherwise, if the neon lamp glows when more than one slide switch is pressed to "P" position, the tube is defective and should be discarded without further test. This simply indicates filament or heater continuity. Unless the tube chart indicates otherwise, it is normal for the neon lamp to glow when only one of the slide switches is pressed to "P" position. The slide switch corresponding to the number in the "filament selector: column is not touched but is left in the "K" position.Ĥ. Press the slide switches up, one at a time to "P" position, and return them to "K" position.ģ. When testing for a short the instructions say:Ģ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |